Juniper Publishers: Framework for Detecting Fault in Real Time Distrib...

Juniper Publishers: Framework for Detecting Fault in Real Time Distrib...: Trends in Technical & Scientific Research Fault tolerance is in the center of distributed system design that covers various metho...

Comments

Post a Comment

Popular posts from this blog

Bioluminescence: Chemical Study on Visible Light Emission from Fungal Mycelium and Fruiting Body - Juniper Publishers

Image
Journal of Trends in Technical and Scientific Research Abstract Although the visible light emission by living organisms is generally thought to be rare, in fact the bioluminescent phenomenon can be widely observed in nature, for examples insects, fishes, bacteria, and fungi. The phenomenon has intrigued scientific researchers over the years.The chemical mechanisms underlying bioluminescence differ between species. Some mechanisms, such as bioluminescence of firefly, jellyfish, bacteria, and dinoflagellate, have been elucidated and further more their principles have allowed the development of many novel technologies in agriculture, biology, ecology, and medicine. However, many other bioluminescence mechanisms yet remain to be understood. Further research of bioluminescence will lead discoveries of biological significance and novel possibility in science. Here I present studies on chemical mechanism underlying fungal bioluminescence, which are act...
Read more

Special Design of Heavy Mass Base Foundations Methods in Rocks and Clay Soil Sub-Surfaces Techniques - Juniper publishers

Image
Journal of Trends in Technical and Scientific Research Abstract These paper constitute consists of parts of foundations design of under and sub structural plans. First of all, foundations are the lowest artificially prepared parts of the structures which are in direct contact with ground surfaces are known as Foundations. But its different categories for the zones of ground ability. Most of the foundations are normal status and load distribution neutralizations in normal bearing values of depends upon the soils. But rocks and clay soil zones areas not suited for normal sub structural design methods. Its followed by high precious design sections and execute the better results. And followed design methods is used for high precious focus in mountain and steep constructions, Water-bearing area, it's also better suitable in heavy constructions mass base foundation methods of high rise buildings system. Keywords: Rock boring; Grout hole; Anchorage bolting sy...
Read more

Effect of Operational Conditions on Performance of Deep Sand Filter in Turbidity Removal - Juniper publishers

Image
Journal of Trends in Technical and Scientific Research Abstract In this study, laboratory pilot plant was constructed to study the performance of deep sand filter in water treatment. Sand was used as a filtration media under different filtration rates ranged from 4 m/hr to 8 m/hr. Down flow was applied to the filter through sand media with size of 0.7-1.0 mm, while sand depth was changed from 80 cm to 140 cm. The used synthetic turbid water was prepared in different turbidity levels varying from 10 to 30 NTU. Aluminum sulfate (alum) was used as coagulant in different doses varied from 20 to 40 mg/l. Turbidity removal and head loss were investigated as functions of sand depth, filtration rate, alum dose and influent turbidity. From analysis of the experimental results, it was found that the changing of operational conditions (changing media depth, filtration rate, alum dose and influent turbidity) have significant impact on the turbidity removal efficiency, head...
Read more